Bosch ConnectModule Bracket

You need the Bosch ConnectModule holder to attach the GPS tracker to your e-bike motor. The holder is mounted behind the motor cover and is well protected from unauthorised access. You only need a new ConnectModule holder in the event of a defect, for example during installation. For retrofitting the Bosch GPS Tracker ConnectModule, we recommend the complete retrofit kit.

Features of the Bosch ConnectModule holder

• original replacement holder for GPS Tracker
• for secure mounting of the ConnectModule
• only for Smart System motors
• variant for Performance Line CX & Cargo Line
• variant for Performance Line

Bosch ConnectModule holder Performance Line CX & Cargo Line

Depending on the motor type, you will need a different holder for your e-bike. For e-bikes with Cargo Line Gen.4 Smart System or Performance Line CX Gen.4 Smart System drive, the holder is made of soft rubber. This is inserted in a form-fitting manner on the left-hand side of the motor, next to the cable connections. Now the ConnectModule can be inserted into the appropriate slot and screwed to the motor.

Bosch ConnectModule mount on the Performance Line motor

For Performance Line Gen.3 Smart System drives there is also a suitable holder for the tracking module. This is made of plastic and is attached to a mounting plate on the motor. The Bosch Connect Module can then be mounted on it.

Note: If you are unsure about compatibility, you can contact our customer service.